Memory BAT mapping: BAT2=256Mb, BAT3=256Mb, residual: 512Mb Total memory = 512MB; using 1024kB for hash table (at c0400000) Linux version 2.4.21 (kay@giga) (gcc version 2.95.4 20011002 (Debian prerelease)) #10 Wed Jul 9 18:35:13 PDT 2003 Found Uninorth memory controller & host bridge, revision: 17 Mapped at 0xfdf0c000 Found a Keylargo mac-io controller, rev: 3, mapped at 0xfde8c000 Processor NAP mode on idle enabled. PowerMac motherboard: PowerBook Titanium II PMU driver 2 initialized for Core99, firmware: 0c Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->0 Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->1 Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->0 On node 0 totalpages: 131072 zone(0): 131072 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/hda3 ro PowerMac using OpenPIC irq controller OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc63d000 OpenPIC timer frequency is 4.166666 MHz GMT Delta read from XPRAM: -420 minutes, DST: on time_init: decrementer frequency = 24.966218 MHz Console: colour dummy device 80x25 Calibrating delay loop... 548.86 BogoMIPS Memory: 513664k available (2100k kernel code, 1112k data, 164k init, 0k highmem) AGP special page: 0xdffff000 Dentry cache hash table entries: 65536 (order: 7, 524288 bytes) Inode cache hash table entries: 32768 (order: 6, 262144 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) POSIX conformance testing by UNIFIX PCI: Probing PCI hardware Can't get bus-range for /pci@f2000000/cardbus@1a Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Thermal assist unit not available Starting kswapd Journalled Block Device driver loaded devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x0 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). PCI: Enabling device 00:10.0 (0086 -> 0087) radeonfb: ref_clk=2700, ref_div=12, xclk=16615 from OF radeonfb: detected DFP panel size from registers: 1152x768 Console: switching to colour frame buffer device 144x48 Registered "ati" backlight controller, level: 15/15 radeonfb: ATI Radeon M6 LY DDR SGRAM 16 MB radeonfb: DVI port LCD monitor connected radeonfb: CRT port no monitor connected input0: Macintosh mouse button emulation pty: 256 Unix98 ptys configured Generic RTC Driver v1.07 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) sungem.c:v0.97 3/20/02 David S. Miller (davem@redhat.com) eth%d: MII PHY ID: 1410c60 M1011 (Marvel ?) eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:03:93:66:7b:2e PPP generic driver version 2.4.2 Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ide0: Found Apple KeyLargo ATA-4 controller, bus ID 2 ide1: Found Apple KeyLargo ATA-3 controller, bus ID 0 ide2: Found Apple KeyLargo ATA-3 controller, bus ID 1 Probing IDE interface ide0... hda: IBM-IC25N020ATDA04-0, ATA DISK drive hda: Enabling Ultra DMA 4 Probing IDE interface ide1... hdc: MATSHITACD-RW CW-8121, ATAPI CD/DVD-ROM drive hdc: Enabling MultiWord DMA 2 Probing IDE interface ide2... ide0 at 0xe22e0000-0xe22e0007,0xe22e0160 on irq 19 ide1 at 0xe22e4000-0xe22e4007,0xe22e4160 on irq 20 hda: attached ide-disk driver. hda: host protected area => 1 hda: 39070080 sectors (20004 MB) w/1806KiB Cache, CHS=38760/16/63, UDMA(66) hdc: attached ide-cdrom driver. hdc: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache, DMA Uniform CD-ROM driver Revision: 3.12 ide-floppy driver 0.99.newide Partition check: /dev/ide/host0/bus0/target0/lun0: [mac] p1 p2 p3 p4 p5 p6 p7 p8 p9 ide-floppy driver 0.99.newide Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] orinoco.c 0.13b (David Gibson and others) hermes.c: 4 Dec 2002 David Gibson orinoco_cs.c 0.13b (David Gibson and others) airport.c 0.13b (Benjamin Herrenschmidt ) Airport at physical address 80030000 Yenta IRQ list 0000, PCI irq58 Socket status: 30000086 eth1: Station identity 001f:0001:0008:0046 eth1: Looks like a Lucent/Agere firmware version 8.70 eth1: Ad-hoc demo mode supported eth1: IEEE standard IBSS ad-hoc mode supported eth1: WEP supported, 104-bit key eth1: MAC address 00:30:65:14:A9:95 eth1: Station name "HERMES I" eth1: ready airport: card registered for interface eth1 Macintosh non-volatile memory driver v1.0 apm_emu: APM Emulation 0.5 initialized. usb.c: registered new driver usbdevfs usb.c: registered new driver hub PCI: Enabling device 10:18.0 (0000 -> 0002) host/usb-ohci.c: USB OHCI at membase 0xe22f4000, IRQ 27 host/usb-ohci.c: usb-10:18.0, Apple Computer Inc. KeyLargo USB adb: starting probe task... usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Enabling device 10:19.0 (0000 -> 0002) host/usb-ohci.c: USB OHCI at membase 0xe22f6000, IRQ 28 host/usb-ohci.c: usb-10:19.0, Apple Computer Inc. KeyLargo USB (#2) usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers usb.c: registered new driver serial usbserial.c: USB Serial Driver core v1.4 usbserial.c: USB Serial support registered for PL-2303 pl2303.c: Prolific PL2303 USB to serial adaptor driver v0.9 mice: PS/2 mouse device common for all mice NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 131072 bind 65536) IPv4 over IPv4 tunneling driver GRE over IPv4 tunneling driver NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. IPv6 v0.8 for NET4.0 IPv6 over IPv4 tunneling driver 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller adb devices: [2]: 2 c3 [3]: 3 1 [7]: 7 1f ADB keyboard at 2, handler 1 Detected ADB keyboard, type ANSI. input1: ADB HID on ID 2:2.c3 input2: ADB HID on ID 7:7.1f ADB mouse at 3, handler set to 4 (trackpad) input3: ADB HID on ID 3:3.01 adb: finished probe task... kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 164k init 8k chrp 36k prep Adding Swap: 524280k swap-space (priority -1) EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,5), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,6), internal journal EXT3-fs: mounted filesystem with ordered data mode.